|
|
|
|
Easystack ModularClick the individual drawing to magnify
SPECIFICATION S.1Boiler tappings are one-off flanged flow and return connections and seven
tappings which are fitted on the side and rear to accommodate altitude gauge,
thermometer, air vent, safety valves, limit and control thermostats. A drain
cock is mounted at the rear of the boiler. A control high limit dual thermostat
is supplied as standard pre-wired and a short flexible oil connection and
strainer. An Electronic temperature controller, combining operating and limit
function complete with type K Thermo couple located in common flow header can be
supplied as an optional extra. SPECIFICATION S.2This boiler unit is fully packaged, all as S.1, but includes mountings and meets relevant Ministry specifications, with particular reference to M & E 3. Thermostats are supplied as standard, pre-wired together with short flexible oil connections and strainer. Packaged unit includes boilers with fully insulated casings up to 100mm and/or to the relevant British Standard. Boiler tappings are one-off flanged flow and return connections and seven tappings with fitted altitude gauge, thermometer, safety valve and control limit dual thermostat in pocket, open air vent, spare tapping for high/low thermostat. SPECIFICATION S.4Boiler
only otherwise all as S.1, supplied with casing and boiler front plate to suit
burners being supplied by customer. SPECIFICATION S.5Comprehensive
boiler to any of the above specifications complete with mixing shunt pump and
all interconnecting pipe work, valves and fittings. Details on request. SPECIFICATION S.6Boilers
supplied to any of the above specifications as combination units complete with
hot water cylinders. Details on request. COMPACT DESIGNThe EASYSTACK MODULAR 3 pass wet back boiler with pressurised combustion chamber is designed to allow the first and second passes of gas to be made within the chamber. The vertically stacked design offers obvious space saving and greater flexibility/turndown ratio. There is also the facility to isolate individual boilers within modular arrangement. BOILER MAINTENANCEThe oil or gas burner supplied is mounted on a firing door, which is insulated together with a refractory lining and seal on the inside of the boiler. In addition, a hinged door is provided at the front of the boiler for access to the third pass, together with an inspection plate at the rear of the boiler. Dual left/right hand opening supplied as standard. QUALITY AND EFFICIENCYUnits, insulated to the relevant British Standards, are working under pressurised combustion overcoming light-up or cold start resistance. Each boiler is constructed from boiler quality steel plates and complies to all the relevant International, British and Ministry standards. Quality has been assessed by BSI Quality Assurance Service to BS5750, certificate No. FM1566. TablesMinimum static head all models three metres. Minimum
clearance: at front for burner projection; at rear for pipework only; at sides
no clearance necessary. Please contact
our drawing office for more specific information. All dimensions and
relevant connections are in mm
Gas rates are based on gross cal. value of 38.7 mj/m3 Gas
pressure at inlet on all models 17.5 mbar. NW1-NW5 flow and return
connections BSP. Female Sockets. NW6-NW15 flow and return connections
flanged to BS.4504. Table 6/5. All flue connections are collars to take the Spigot end of standard flue pipe.
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Copyright © 2007 HOVAL Ltd |
